Sanyo PLC-XW10, Service Manual

Page: 21 / 92

-21-
Optical Adjustments
Fig.2-
2
INTEGRATOR LENS ADJUSTMENT
[Before Adjustment]
- Adjustment requires a 2.0mm hex driver and a slot screwdriver.
- Remove cabinet top following to “Cabinet Disassemblies”.
Note: Do not disconnect the connectors on main and component
boards otherwise the projector can not be turned on.
[ADJUSTMENT]
1. Turn on lamp by a state of without FPC cable of LCD panels.
2. Project only green light component Shield the red and blue lights
by inserting thick papers etc. in front of Red and Blue LCD panels
to project only green light and make a fine focus.
3. Remove the shield in front of Red LCD panel to project green and
blue light.
4. Adjust the adjustment base of integrator lens ass’y to make color
uniformity in yellow.
1) If the color shade appears on the left or right of the screen as
shown in Fig.2-1, loosen 1 screw
A
with the 2.0mm hex driver
and adjust a slot
B
to make color uniformity in yellow by turn-
ing a slot screwdriver.
2) If the color shade appears on the top or bottom of the screen
as shown in Fig.2-2, loosen 2 screws
C
with the 2.0mm hex
driver and adjust a slots
D
to make color uniformity in yellow
by turning a slot screwdriver.
5. Tighten 1 screw
A
and 2 screws
C
to fix the integrator lens unit.
6. Remove the shield in front of Blue LCD panel and project red,
green and blue light. Check that there is no color shade on the
left or right of the screen. If you recognise the color shade, the
“Relay Lens Adjustment” should be carried out to obtain the prop-
er color uniformity.
y
x
Moving of Slots D
Slot D
C
a b
a b
Moving of slot B
Fig.2-
1
Slot B
Slot D
A
C
y
x
Yellow
Yellow