Sanyo PLC-XU301A, Owner'S Manual

Page: 45 / 79

Setting

Note:
•
Auto Keystone
corrects vertical distortion only,
not correct horizontal distortion.
• The Auto Keystone function cannot work when
the
Ceiling
feature is set
On
in the Setting menu
(p.50).
• Perfect correction of the image distortion cannot
be ensured with the Auto setup function. If the
distortion is not corrected properly by pressing the
AUTO SETUP or the AUTO SET button, adjust
manually by pressing the KEYSTONE button on
the remote control or selecting
Keystone
in the
Setting menu (pp.23, 46).
•
Fine sync
,
Total dots
,
Horizontal
and
Vertical
position of some computers cannot be fully
adjusted with the Auto PC Adjustment function.
When the image is not provided properly with
this operation, manual adjustments are required
(pp.31-32).
Auto setup
Input search
This function detects the input signal automatically. When
a signal is found, the search will stop. Use the Point
▲▼
buttons to select one of the following options.
Off
........... Input search will not work.
On1
.......... Input search works under the following situation.
– When pressing the AUTO SETUP button on
the top control.
– When pressing the AUTO SET button on the
remote control.
On
.......... Input search works under the following situation.
– When turning on the projector by pressing the
ON/STAND-BY button on the top control or the
remote control.
– When pressing the AUTO SET button on the
remote control.
– When pressing the AUTO SETUP button on
the top control.
– When the current input signal is cut off.*
* If the No show or Freeze function is active, cancel it to
activate the Input search. It is also unavailable when On-
Screen menu is displayed.
Auto PC adj.
On
. . . . . . . .Enables Auto PC Adjustment when pressing
the AUTO SET button on the remote control or
the AUTO SETUP button on the top control.
Off
. . . . . . .Disables Auto PC Adjustment.
Auto Keystone
Auto
. . . . . Always works and corrects keystone distortion
according to the projector's tilt.
Manual
. . . .Works only when pressing the AUTO SETUP
button on the top control or the AUTO SET
button on the remote control.
Off
. . . . . . .Disables Auto Keystone.
Auto setup

Note:
• While
Input search
is set to
On1
or
On
, the status of Input
and Lamp are displayed every time the signal is switched.
• Only the last selected input source can be detected.
• During
Input search
is in progress, if the INPUT button on
the top control, the COMPUTER1/2 button, the S-VIDEO
button, the COMPONENT button or the VIDEO button on
the remote control, the MENU button or the ON/STAND-BY
button is pressed,
Input search
will stop. If the INPUT button
is pressed, the
Input search
will go back to the current seach
signal. If the COMPUTER 1/2 button or VIDEO or S-VIDEO or
COMPONENT button is pressed,
Input search
will go back to
the button's input signal.
•
Input search
,
Auto PC adj.
and
Auto Keystone
cannot be
set
Off
at the same time.
This function enables Input search, Auto Keystone correction
and Auto PC adjustment by pressing the AUTO SETUP button
on the top control or the AUTO SET button on the remote
control. Settings for those functions can be altered as follows:
Closed caption