45
Setting
Ceiling
Rear
Ceiling
When this function is set to “On,” the picture is top/bottom
and left/right reversed. This function is used to project the
image from a ceiling-mounted projector.
Rear
When this function is set to “On,” the picture is left/right
reversed. This function is used to project the image to a
rear projection screen.
Terminal
The COMPUTER IN 2/MONITOR OUT terminal on the back
of the projector is switchable for computer input or monitor
output (p.9). Select Computer 2 or Monitor Out with the
Point
7 8
buttons.
Computer 2 .......... computer input
Monitor Out ......... monitor out
Terminal function is not available when selecting Computer
2 to the input source. Change the input source to the others
(Computer1 or Video) so that the Terminal function is
available (pp.26, 35–36).
Power management
Time left before Lamp is off.
Press the SELECT button
at Power management and
this box appears. Select
one of three settings with
the Point
7 8
buttons, and
go to the timer with the
Point
ed
buttons and set
time with the Point
7 8
buttons.
Power management
For reducing power consumption as well as maintaining the
lamp life, the Power management function turns off the
projection lamp when the input signal is interrupted and no
button is pressed for a certain period.
When the input signal is interrupted and no button is
pressed for more than 30 seconds, the timer display with
“No signal”appears. The countdown starts to turn off the
lamp.
Select one of the operations.
Ready ................. When the lamp has been fully cooled
down, the POWER indicator changes to
green blinking. In this condition, the
projection lamp is turned on if the input
signal is reconnected or any button on
the top control or on the remote control
is pressed.
Shut down.......... When the lamp has been fully cooled
down, the power is turned off.
Off ...................... Power management function is off.
Then set the countdown timer with the Point
7 8
buttons.
