Sanyo PLC-XF47, Owner'S Manual

Page: 19 / 82

19
Terminals of Projector
This projector applies various input/output terminals and 4 terminal slots for expansion to tune to diversity
of signals from computers and video equipment. 4-built-in Terminal Slots enable you to arrange desired
combinations of input sources just by changing Terminal Boards. For Terminal Boards, contact sales dealer
where you purchased a projector.
Pull out the terminal by holding handle.
Remove 2 Screws on a terminal.
1
2
Tighten screws to secure the terminal.
Replace the terminal. Insert a new terminal along
Guide to fit Plug into Socket.
3
4
ANALOG
G B R H/HV V
DIGITAL (DVI-D)
INPUT 1
R/C JACK USB
RESET
INPUT 2
INPUT 3
INPUT 4
SERIAL PORT IN
SERIAL PORT OUT
L
VIDEO/Y Pb/Cb Pr/Cr
S-VIDEO
W
INPUT/OUTPUT
TERMINALS
Screws
Guide
Socket
Plug
Figure shows D-sub 15 terminal.
DVI / D-sub 15 Terminal
5-BNC / VideoTerminal
4 TERMINAL SLOTS (Factory set)
NOTES ON ORDERING OR USING
OPTIONAL INTERFACE BOARD
When ordering or using Optional Interface Board (Termi-
nal Board), contact your sales dealer. When contacting the
sales dealer, tell the Option Control Number (Op.cont.No.)
in the menu that is located on the bottom of the information
menu.(See page 28)
Note:
• In the replacement of terminal board, the MAIN
ON/OFF switch should be OFF position.
Replacement of Terminal
Installation