12
Part Names and Functions
To ensure safe operation, please observe the following precautions :
● Use two (2) AAA or LR03 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
● Risk of an explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions or your local disposal rule or guidelines.
Open the battery
compartment lid.
Install new batteries
into the compartment.
Replace the
compartment lid.
Two AAA size batteries
For correct polarity
(+ and –), be sure
battery terminals are
in contact with pins in
compartment.
1
2
3
Point the remote control toward the projector (Infrared
Remote Receiver) when pressing the buttons. Maximum
operating range for the remote control is about 16.4'(5 m)
and 60 degrees in front of the projector.
Remote Control Operating Range
Remote Control Battery Installation
16.4'
(5 m)
30° Remote control
30°
The 2 different remote control codes (Code 1–Code 2) are
assigned to this projector. Switching the remote
control codes prevents interference from other remote
controls when several projectors or video equipment
next to each other are operated at the same time. Change
the remote control code for the projector first before
changing that for the remote control. See "Remote control"
in the Setting Menu on page 52.
Press and hold the MENU and IMAGE buttons for more
than five seconds to switch between the
Code 1
and
Code
2
. The initial code is set to
Code 1
.
Remote Control Code
MENU button
IMAGE button
Downloaded From projector-manual.com Sanyo Manuals
