49
Setting
Setting
Remote control
This projector provides two different remote control
codes: the factory-set initial code (Code 1) and the
secondary code (Code 2). This switching function
prevents remote control interference when operating
several projectors or video equipment at the same
time.
When operating the projector in "Code 2", both the
projector and the remote control must be switched to
"Code 2".
To change the code for the projector:
Select either "Code 1" or "Code 2" in this Setting Menu.
To change the code for the remote control:
Press and hold both the MENU and IMAGE buttons
together for 5 seconds or more. After changing the
code, make sure the remote control operates properly.
Remote control
Press and hold
M E N U a n d
IMAGE buttons
for more than 5
seconds.
On start
W h e n t h i s f u n c t i o n i s " O n " , t h e p r o j e c t o r i s
automatically turned on just by connecting the AC
power cord to a wall outlet.
Note:
Be sure to turn the projector off properly (see
"Turning Off the Projector" on page 20). If the
projector is turned off in the incorrect sequence,
the On start function does not operate properly.
Lamp control
This function allows you to change brightness of the
screen.
Auto.............. brightness according with the
input signal
High.................Brighter than the Normal mode.
Normal........... normal brightness
Eco .................lower brightness reduces the lamp
power consumption and extends
the lamp life.
