17
Disassembly and Assembly instructions
㻷㻢㻜㻝
㻷㻢㻭
㻷㻢㻮
㻷㻢㻯
㻷㻵㼂㻝
㻷㻵㼂㻞
㻷㻢㻜㻝
㻷㻢㻭
㻷㻢㻮
㻷㻢㻯
㻷㻵㼂㻝
㻷㻵㼂㻞
1. Remove the couplers that are connected to the Power board.
Couplers on the Power board: K601, KIV2, KIV1, K6C, K6B,
K6A
6. Replacement method for Power board
2. Remove the screws (47V type: 9 screws, 42V type:
screws) that screw the Power board in place. (SCR PAN+
SW+W 3X) Pull out the boss (plastic) that holds the
Power board.
3. Remove the Power board carefully and replace it with the
repair board. (The repair board is equipped with a fuse.)
1. Remove the K601 connector for the AC cord bracket from
the Power board.
2. Remove 1 screw that screws in the earth wire for the
AC cord.
Screw: SCR BIN 4X6
䕔
Precautions when installing
䞉
Be careful not to set the direction of the earth for
the AC inlet assembly in the wrong direction.
䞉
When replacing the Holder AC, affix the Spacer Sheet
and get it ready before replacement.
3. Pull out the AC cord bracket from the slit on the cabinet
back.
4. Remove the screws (Qty. 2) and nuts (Qty. 2) shown in
the illustration, and then remove the AC cord component.
䚷
Screw: SCR BRZ 3X10, Nut: NUT HEX 3
7. Replacement method for AC cord
bracket
42V type
47V type
K601
Earth wire
5. Replace the AC cord.
AC cord
Holder AC
Spacer
Sheet
42 type
47 type
