9
SETTING-UP PLASMA MONITOR
PREPARATION
This Plasma Monitor uses nominal input voltages of 100-
120 V or 200-240 V AC. The Plasma Monitor
automatically selects the correct input voltage. It is
designed to work with single-phase power systems
having a grounded neutral conductor. To reduce the risk
of electrical shock, do not plug into any other type of
power system.
Consult your authorized dealer or service station if you
are not sure of the type of power supply being in use.
Connect Plasma Monitor with the peripheral equipment
before turning Plasma Monitor on. (Refer to pages 13 ~
15 for connection.)
CAUTION
For safety, unplug the AC Power Cord when the
appliance is not used.
CONNECTING AC POWER CORD
Connect AC Power Cord
(supplied) to
Plasma
Monitor.
The AC outlet must be near
this equipment and must be
easily accessible.
To the POWER CORD CON-
NECTOR on
Plasma
Monitor
Plasma Monitor side
AC Outlet side
Ground
NOTE ON THE POWER CORD
The AC Power Cord must meet the requirement of the country where you use the Plasma Monitor.
Confirm the AC plug type with the chart below and the proper AC Power Cord must be used.
If the supplied AC Power Cord does not match the AC outlet, contact your sales dealer.
To the AC Outlet.
(120 V AC)
For Continental Europe
For the U.S.A. and Canada
For the U.K.
To the AC Outlet.
(220 - 240 V AC)
To the AC Outlet.
(220 - 240 V AC)
Table Top Stand
(Option)
When you connect The Plasma Monitor to AC
outlet, attach the supplied ferrite cores. Set the
ferrite cores on the both ends of the AC power
cord . Close the lid tightly until the clamps click.
ATTACHING THE FERRITE CORES
Ferrite cores (supplied)
