PDG-DHT8000L Expand Serial Command Functional Specifications
27/101
8.5
PC Control Command
8.5.1 CF_FSYNC Command
Command
“CF_FSYNC_%1” [CR]
%1
“0000-0031” ----------------- Directly specify setting value of Fine Sync
“UP” --------------------------- Increment setting value of Fine Sync by 1
“DN” --------------------------- Decrement setting value of Fine Sync by 1
Details
Set value of Fine Sync in PC signal (Available only in the normal Power ON status)
The value set by this command is not stored in the projector’s memory. Therefore,
when the power is turned to ALL OFF status, the value returns to the original
setting. (It is stored in Suspend mode.)
Acceptable
“000” [CR]
Response
Unacceptable
“101” [CR] --- When input is Video signal
--- When input is no signal
8.5.2 CF_TDOTS Command
Command
“CF_TDOTS_%1” [CR]
%1
“mmmm – nnnn” --------------- Directly specify setting value of Total Dots
“mmmm” indicates minimum value, which is current (Display Area H + Position H) value
“nnnn” indicates maximum value, that dot clock does not exceed more than 160MHz.
“UP” ------------------------- Increment setting value of Total Dots by 1
“DN” ------------------------- Decrement setting value of Total Dots by 1
Details
Set value of Total Dots in PC signal (Available only in the normal Power ON
status). The value set by this command is not stored in the projector’s memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable
“000” [CR]
Response
Unacceptable
“101” [CR] --- When input is Video signal
--- When input is no signal
8.5.3 CF_H-POS Command
Command
“CF_H-POS_%1” [CR]
%1
“0000-nnnn” -------- Directly specify setting value of Horizontal Position
“nnnn” indicates maximum value, which is current value of (Total Dots – Display Area H)
“UP” ------------------- Increment setting value of Horizontal Position by 1
“DN” ------------------ Decrement setting value of Horizontal Position by 1
Details
Set value of Horizontal Position in PC signal (Available only in the normal Power
ON status)
The value set by this command is not stored in the projector’s memory. Therefore,
when the power is turned to ALL OFF status, the value returns to the original
setting. (It is stored in Suspend mode.)
Acceptable
“000” [CR]
Response
Unacceptable
“101” [CR] --- When input is Video signal
--- When input is no signal
