Sanyo LCD-46XR10F, Service Manual

Page: 12 / 45

NA06 5272402002 AT24C02
HDMI EDID (for
example,
supporting the
third channel
HDMI)
Yes ALL11
N106 5272402002 AT24C02 VGA EDID Yes ALL11
Note 1:
Method of
w
rite-protect setup: enter into burning interface of ALL-100, tick option “
Config
”,
press item “
config Setting
”, set option “
Protect
” as “
All Protect
”; make sure that option
“
Config
” must be ticked before burning software and write-protect must be reset after
ALL-100 burning software opened every time.
Note 2:
Method of burning and upgrading software by using ISP burning device:
1
）
For main board upgrade: Connect the cable of ISP burning device to Debug port (
X107
) of main
board; for TV set upgrade, connect both VGA ports of ISP burning device and main board, enter
into factory menu and set item “
ISP Mode
” as “
ON
”;
2
）
Using
Mstar
online burning program (
V4.4.2.0
or higher versions), enter into menu “
Device
”, tick
option “
WP Pin pull to high during ISP
” to ensure that hardware write-protect of Flash is
removed and erasing process is normal, please refer to Fig. 2;
Fig. 2 Write-protect setup
Factory software burned instructions listed as Table 5
Table 5 Factory software burned instructions
No. Part No. Part Type
Software
function
Burned
before SMT
Burning method
N803 5276405001 MX25L6405DMI-12G FLASH Yes
Use ALL11 with write-protect, refer
to Note 1 in detail.
N804 5272404002 AT24C04 HDCP KEY Yes ALL11
NA04 5272402002 AT24C02 HDMI EDID Yes ALL11
NA05 5272402002 AT24C02 HDMI EDID Yes ALL11
Method of software upgrading
instructions