10
5-3) Normal (Normal)
Press up or down key can select high light item function.
Press OK key to enter the item.
Following data for color temp shall be edited manually.
-R, G, B data for each preset.
-Press “Up” or “Down” key to select “R”, “G”, “B” item
-Press “Left” or “Right” key to set the “R”, “G”, “B” value.
-Press “MENU” or “BACK” item to exit to factory mode
5-4) Timer Clear
Press up or down key can select high light item function.
Press Right key to enter the item.
Reset the timer which records hours of LCD panel burn in.
5-5) Preset Channel
Press up or down key can select high light item function.
Press Right key to enter the item.
The system will be loaded preset channel for production line.
- ATV(Analog TV), DTV(Digital TV)
5-6) NVRAM Clear
Initialize program’s default values to NVRAM for following adjustment items accuracy.
In factory mode it is the first and important step to make sure all values are default value and correct.
-
Reset settings: Gamma table, Channel table (Favorite channel, Channel label etc.), Model table
(H/V Position, Clock, Phase), Source dependent setting (Contrast, Brightness etc.), Common
setting (Volume, Language etc.), Parental Control (Rating, Password etc).
To avoid a mistake initial process after factory setting is done. This item will have a check dialog “yes or no”
to do the initial or not.
NOTICE:
After this item is processed then needs to be DC powered on/off.
5-7) Full power
This is for power consumption testing.
To measure the maximum power consumption of TV set, we adjust the value of following items to maximum.
- Contrast
- Brightness
- Audio
output
5-8) Source Calibration
Auto Calibration (gain/offset) must be adjusted color by firmware automatic adjustment in PC, Video1
(Composite) and Video3 input source.
5-9) Reset to Default
Reset all settings of OSD menu to default value and will go to standby mode.
-
Reset settings: Channel table, Model table (H/V Position, Clock, Phase), Source dependent setting
(Contrast, Brightness etc.), Common setting (Volume, Language etc.)
5-10) RF Burn In
RF (ANT) no signal input, use “snow” pattern for burn in.
5-11) RF F/W Upgrade
Press Right key to enter the item.
To avoid a mistake F/W Upgrade process after factory setting is done. This item will have a check dialog
“yes or no” to do the upgrade or not.
Summary of Contents for LCD-32E30A
