Sanyo LCD-19XR9DA, Service Manual

Page: 6 / 51

Preset ex-factory
Fig-1 adjustment flow-chart
4. Adjustment instruction
4.1 Unit adjustments
4.1.1Connect all the boards according to wiring diagram, then power on and observe the display.
4.1.2 Method for entering factory menu:
a) Press “SOURCE”, “2”, “5”, ”8” and “0” in turn to enter factory menu;
b) Press “ ” and “ ” to move the cursor to the adjustment page of the level one factory menu,
then press ”OK” to enter;
c) Press “ ” and “ ” to move the cursor up and down;
d) Press “ ” and “ ” to adjust the item when the cursor move to a certain adjust item;
e) Press “MENU” to exit to the previous factory menu;
f) Press “EXIT” to exit the factory menu at any situation;
g) Press “OK” to enter the sub factory menu;
h)
ADC ADJUST
, ADC correction of VGA, Component channel;
i)
W/B ADJUST
, white balance adjustment;
j)
POWER MODE
, set the turn-on modes. Standby---standby when power on; Mem---memory;
ForceOn---power on; ForceOn can be used for aging; set the “power mode” to “Standby” when
preset ex-factory unless the client appointed it;
k)
ISP MODE
, ON---soft upgrading through VGA port with ISP instrument, OFF---DDC function of
VGA; the setting will not be memory and will be “OFF” when power on again;
l)
RESTALL
, initialization of the factory and user data; after this item is confirm, the unit will restart
and display the guiding image.
m)
FACTORYDATAREST
, factory data initialization (including white balance adjustment, ADC
correction and other adjusted data);
n)
FACEORY Channel PRESET
, preset the factory channel; please connect to the center signal
source when operating; the present digital frequency is CH28(529.5MHz), CH33(564.5MHz) for
Australia, if the signal changes, perform “DTV manual search” in “Channel” menu and the
operation needs 15s or so.
o)
CUSTOM Channel PRESET
, preset the custom ATV channel, they are CH2(66.5MHz),
CH7(184.5MHz), CH9(198.5MHz), CH10(212.5MHz), CH28(529.5MHz);
p)
MST DEBUG
, the default is OFF. OFF---RS-232 should match the design criterion; ON--- it
should be convenient for using exploitation tool to adjust. The setting will not be memory and will
be “OFF” when power on again;
q)
BACKLIGHT
: adjust the backlight brightness, adjust the data and test the voltage of X804 pin2
(PWM), let the voltage to be the corresponding PWM voltage which the brightness is maximum.
It will be preset and doesn’t need adjust.
r)
SSC ADJUST
, adjust the frequency spectrum expand, it will be preset and doesn’t need adjust.
s)
AUDIO CURVE
, adjust the sound curve, it will be preset and doesn’t need adjust.
t)
RF AGC delay Adj
, adjust ATV RF AGC-take;
u) There is data in EEPROM after software upgrade, please perform REST ALL before the first
adjustment.
4