19
(Remote control display)
Massaging
rollers
MASSAGING (AUTOMATIC COURSES) (continued)
Displays the aim of massaging positions, the
type of massaging and the remaining
massaging time on the remote control.
The explanation uses NECK & SHOULDER
as an example.
Adjusting the strength of massage
NOTE
Massaging operation and display of remote control
Measurement of shoulder position
Massaging rollers move up and down
to measure the position of shoulder.
(Sit deeply on the massage chair and raise your
head slightly. The matching of the position of
shoulders may not be possible if the head is
leaning on the back rest.)
Massaging operation at recognized
position of shoulder.
Check that massaging rollers match
the position of your shoulder.
If not, when the lamp of is
flickering (a beep sounds),
adjust the position by pressing
the POSITION ADJUST buttons.
The massaging rollers are
moved up or down by 1cm
each time the POSITION
ADJUST button is pressed.
When it is difficult to
adjust with POSITION
ADJUST button, move
your body for adjustment.
The height that can be
adjusted is between
approx. 150 to 180cm.
Decides the position of shoulder.
Each time the UPPER (DRUM ROLL) button is pressed, the strength of
upper body (drum roll) massaging can be adjusted in five stages.
(The strength is displayed by the lamp on the remote control.)
Each time the LOWER BODY STRENGTH ADJUST button is pressed, the
strength of lower body massaging (air) can be adjusted in three stages.
(The strength is displayed by the lamp on the remote control.)
When it is felt that the massaging on the soles or calves is too strong even when reducing the
strength of lower body (air) massaging, put a towel etc. on those massaged parts.
The position of current massage
flickers.
The timer will operate and then
stop. After the rollers have
retracted, the display will turn off.
Massaging concentrated on the
neck and shoulders will be carried
out.
Position too high
Position too low
Appropriate position
●
●
●
●
