BEFORE INSTALLING THE UNIT
Transport lock screws
The mechanism in the CD changer is “locked” into place during shipment by the transport
screws, Be sure to remove the screws prior to installation.
Caution
After removing the transport lock screws, place the supplied seals over the screw holes. These seals are used to keep dust out of
the unit, which could cause a malfunction.
Installation and Wiring Precautions
To prevent a short-circuit,
l
Be sure to turn off the ignition and remove the negative (-) battery cable, prior to installation.
Connect power wires (yellow) last.
N o t e
If the changer is to be installed in a car that is equipped with an on-board drive or navigation computer, do not disconnect the bat-
tery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution during instal-
lation, not to cause a short circuit.
Do not install the unit in the following locations.
l
Locations exposed to direct sunlight.
l
Where hot air is discharged from the car heater.
l
In areas subject to extreme temperatures.
Incorrect installation can cause the sound to “skip” when playing a disc.
Mount the unit firmly in place, using the supplied
b r a c k e t s a n d s c r e w s .
Be careful not to damage the car wiring.
l
Be sure to use the supplied screws.
l
Be careful not to snag any wires when tightening screws and installing the ground wire.
l
Do not use any of the screws that are part of the brake or steering system, to install the unit.
l
Install the unit as closely to vertically or horizontally as possible. If the unit must be inclined, the angle must be 15” or
Installation and inclination angle
I nstallation
Angle
mounting
Vertical mounting
15” max.
max.
,
