6
During in the STANDBY mode.
1. Press and hold the MEM/C-ADJ./iPod button until the time displays will change to 24-hour digit
and flash.
2. Press or button to select 12-hour or 24-hour.
3. Press the MEM/C-ADJ./iPod button again, the HOUR digit will flash on the display, press or
button to adjust HOUR digit.
4. Press the MEM/C-ADJ./iPod button once more, the MINUTE digit will flash on the display, press
or button to adjust minute digit.
5. Press the MEM/C-ADJ./iPod button again to confirm the time.
6. Each enable state as shown above will be cleared if the key is not pushed in10 seconds.
CLOCK SETTING
TIMER SETTING
FUNCTION SELECT
The function is that when
FUNCTION button, the mode is changed. Display changes as below:
pressing
TUNER
AUX
CD
USB
IPOD
CARD
RADIO OPERATION
Press the FUNCTION button to select “TUNER”.
1. Press the BAND button to select AM or FM.
2. Press
or
button to tune the desired station.
Manual Tuning
To tune for weak stations, use manual tuning by pressing
or b
utton continuously until you read the
correct frequency or the reception is at its best.
Automatic Tuning
1. Press
or
button for a second or more, then release the button. The tuner will automatically search
the first station of sufficient signal strength.
2. Repeat above procedure if you wish to select another station.
1. After adjusting the clock, press the TIMER button for a few seconds, " ON" and "00:00" appear on the display and
the HOUR digit flashes.(F1)
2. Press
or
on the unit
or press
or
button on the remote control to adjust it.
3. Press the TIMER button again, the MINUTE digit will start flashing, adjust it by pressing
or
on the unit or
pressing
or button
on the remote control.
4. Press the TIMER button once more to confirm and order TIMER ON time.
5. After adjusting "TIMER ON", " OFF" appears on the display and the HOUR digit flashes.(F2)
6. Repeat the above steps 2 to 3, and then press the TIMER button once more to confirm and order TIMER OFF time.
7. Now the "TUNER" appears on the display with flashing, and then select the alarm mode of the “
TUNER, CD, USB,
CARD or IPOD
" by pressing
or on the unit
.
8. Press the TIMER button again, the timer "VOL" indicator appears on the display and flashes, adjust the timer
volume high or low by pressing
or
on the unit
or pressing the
or
button on the remote control.
9. Each enable state as shown above will be cleared if the button is not pushed in 10 seconds.
10.After adjusting "TIMER ON" and "TIMER OFF", press the TIMER button, " “ appears on the display.
11.The main unit will be switched on automatically at "TIMER ON" order and start playing, the main unit will be
switched off automatically at "TIMER OFF" order.
Note: If the display shows "ERROR" while you set the “TIMER ON”, it means both “TIMER ON” and “TIMER OFF” is
the same. In this case, please go to “TIMER OFF” to set the off time first. To switch TIMER function ON or OFF,
press TIMER button.
