SETTINGS
Line phase adjustment
When using a camera switcher to connect 2
cameras or more to one monitor, there may be
a vertical roll of the images when switched. In
such a case, set as described below.
1
Set the
Sync
switch to the
L-L
position.
2
Switch the display on the monitor from
camera 1 to camera 2.
Adjust the
LINE PHASE
volume on camera 2
until the vertical roll of the image stops.
If more than two cameras are used, please
repeat this procedure for all the cameras.
CAUTION:
If the vertical roll cannot be corrected by setting
the
LINE PHASE
volume on camera 2, try
setting the
LINE PHASE
volume on camera 1.
If it still cannot be corrected, please check that
the polarity of the power cords of all connected
devices is correct.
INT
EI OFF
EI ON
L-L
LINE
PHASE
12
(Monitor)
L53V2/XE (VCC-5775P) GB 2000, 7, 11
12
English
