E21
E20
Answering a call
ANSWERING WITH THE HANDSET
Make sure the handset POWER switch is ON.
1
When a call comes in, the handset rings.
The IN-USE indicator and the dialing keypad flash.
2
Press
TEL
or any key (except END button)
to answer the call.
If you press the END button, the ringing stops and incoming
call is automatically placed on hold until you press any key.
(except the END button).
3
Press
END
to hang up, or place the handset
in the base station cradle.
Dial light (Handset only)
The dialing keypad of the handset flashes when the phone rings, and lights up for 10
seconds when
TEL
or dialing button is pressed. Press dialing button any time
to light it up again for 10 seconds during a call.
CAUTIONS:
• Do not use this handset near water - for example, in a wet basement or near a
bathtub, kitchen sink or swimming pool. Condensation will result in corrosion
and cause malfunction.
• Never spill liquid of any kind on the handset. Liquid corrosion may cause
malfunction.
• Operating the handset with hands soiled with cooking oil, machine oil, etc. or
leaving the handset exposed to direct sunlight for extended periods can cause
discoloration and fading of the handset keypad. Discoloration or fading will have
no effect on the telephone performance.
To adjust the volume
The handset has 3 volume levels HIGH/MIDDLE/LOW.
Press
▲
or
▼
during a call, to increase or decrease the level.
Note
The volume adjustment provides a minimum of 12 dB difference between the lowest
and the the highest levels.
40-CHANNEL ACCESS/AUTO SCAN
Every time you answer or place a call using the handset, this cordless telephone
automatically selects a clear channel from 40 frequencies available to transmit signals
between the base station and handset. If you notice interference during a call, simply
press the SCAN button on the handset to access a clear channel. To stop scanning
manually, press the SCAN button.
CALL TIMER
The call timer display appears 10 seconds after you begin a call using the handset.
Timer count begins when the line connects between the handset and the base. Elapsed
time appears in minutes and seconds.
Placing a call
USING THE HANDSET
Make sure the handset POWER switch is ON.
1
Press
TEL
and listen for a dial tone.
2
Dial the number.
3
Press
END
to hang up.
(or return the handset to the base station.)
Press
during a call to switch to handsfree conversation
using the handset speakerphone.
Press
TEL
to return to normal conversation using
the earpiece receiver.
END button
TEL button
Dialing button
END button
TEL button
