Mounting on a wall
Do not attempt to wall-mount the phone before initial 12-hour
charging is completed.
Follow steps 1– 3 above to charge the handset.
4.
Remove the handset
from the base and set
aside. Turn the base over
and align the four slots
on the bottom of the base
with the four hook-tabs
on the bracket.
5.
Insert the hook-tabs into
the slots and push up
until the bracket snaps
securely into place.
6.
Plug the telephone line
cord into the
TEL LINE
jack on the back of the
base and into a modular
phone jack.
Note
: If you have PULSE (rotary) telephone line, set the
PULSE/TONE
switch on the back of the base to
PULSE.
7.
Slip the mounting holes over the wall plate posts and slide the
unit down firmly into place. (Wall plate not included.)
8.
Place the handset in the base.
Note:
If desired, gather the extra AC adaptor cord and telephone line
cord together, fasten with a wire tie, and store inside the wall
mounting bracket.
Digital Security System
Your cordless phone uses a digital security system to provide
protection against false ringing, unauthorized access and charges to
your phone line. When you place the handset in the base, the phone
verifies its security code. After a power outage or battery replacement,
you should place the handset in the base for about 20 seconds to reset
the code.
7
Battery setup
1.
Remove the battery compartment cover
on the handset, insert the battery, plug
the cord into the jack (inside the
compartment) and replace the cover.
2.
Set the handset
RINGER
switch to
ON
,
and place handset in the base.
3.
Plug the AC adpator into the
POWER DC
12V
jack on the back of base and the
other end into an electrical outlet. The
CHARGE/PAGE
indicator comes on
verifying the battery is charging.
Charge the handset for
12 continuous hours prior to first use. The
initial battery charge is important for best
performance.
Note:
It is normal for
the handset and base
to get warm when
the handset is
charging in the base.
Note:
For desktop
charging only, the
handset is able to charge facing up or down.
Telephone line connection
4.
Plug the telephone line cord into the
TEL LINE
jack on the back of
the base and into a modular phone jack.
Tone/pulse setting
5.
If you have PULSE (rotary) telephone line, set the
PULSE/TONE
switch on the back of the base to
PULSE.
For touch-tone service
line, do nothing as your phone has been set to
TONE
at factory.
If you do not know which type of service you have, contact your
local telephone company.
Caution:
Use only the Sanyo AC adaptor (U120030D) that is supplied
with this phone. Using another AC adaptor may damage the phone.
6
1
GETTING STARTED
GETTING STARTED
LINE
1
2
3
CLT-2422E-NEW 7/16/02 9:08 AM Page 6
