3
CAUTION:
Please read and retain for your safety.
This unit has been designed and manufactured to assure your personal safety, but
LPSURSHUXVHFDQUHVXOWLQSRWHQWLDOHOHFWULFVKRFNRU¿UHKD]DUGV,QRUGHUQRWWRGHIHDWWKHVDIHJXDUGVLQFRUSRUDWHGLQWKLVPRQLWRUREVHUYHWKH
following basic rules for its installation, use and servicing.
Installation and Use
Do not
allow anything to rest on the power
cord.
Do not
locate this LCD monitor where the
FRUGZLOOEHGDPDJHGE\SHRSOHZDONLQJRQLW
Do not
overload wall outlets and extension
FRUGVDVWKLVFDQUHVXOWLQ¿UHRUHOHFWULFVKRFN
$VXLWDEOHVRFNHWRXWOHWPXVWEHSURYLGHGQHDU
to the monitor and shall be easily accessible.
Do not
place this LCD monitor near any heat
sources such as radiators, heaters, stoves and other heat-generating
SURGXFWVLQFOXGLQJDPSOL¿HUV
Do not
place your LCD monitor on an unstable stand, shelf or table.
Serious injury to an individual, and damage to the LCD monitor may
result if it should fall. Your sales person can recommend an approved
ZDOOPRXQWLQJNLW$VSHFLDOZDOOPRXQWLQJNLWLVDYDLODEOHIRUWKLV
model.
This
LCD monitor should be operated only from the type of power
source indicated on the monitor or as indicated in the Operating In-
structions. If you are not sure of the type of power supply, consult your
sales person or your local power company.
For added protection
it is strongly recommended that this LCD
monitor has its mains supplied via an approved earth fault protection
device.
WARNING:
To prevent injury the LCD monitor must be securely
attached to the wall in accordance with the manufacturers installation
instructions.
IMPORTANT:
This product must be earthed.
This unit is not disconnected from the mains unless the mains lead
LVXQSOXJJHG7KHLQVWDOOHUPXVWPDNHVXUHWKDWWKHZDWHUSURRILQOLQH
coupler is easily accessible.
(CE42LH2WP model only)
This monitor is tested to
IP66
standard rating.
This monitor is
not
protected against temporary or continuous
immersion in liquid.
Do not
use immediately after moving the LCD monitor from a low
temperature to a high temperature environment, as this causes con-
GHQVDWLRQZKLFKPD\UHVXOWLQ¿UHHOHFWULFVKRFNRURWKHUKD]DUGV
%HIRUHFOHDQLQJXQSOXJWKHPRQLWRUIURPWKHZDOOVRFNHW
Do not
PRXQWQHDUDQRSHQÀDPHVRXUFH2SHQÀDPHVPXVWQHYHU
be used near this LCD monitor.
This LCD monitor
should not be built in or enclosed in any way, heat
build up will reduce the life of the monitor.
This LCD monitor should have a minimum distance of 5cm away from
the wall and the monitor should have 10cm distance around the top
and sides.
Always
PRXQWXVLQJUHFRPPHQGHGDQGVXEVWDQWLDO¿[WXUHVDQG¿W
-
tings.
10cm
10cm
10cm
5cm
7KHUHDU¿QQHGVHFWLRQDURXQGWKHFDELQHWIXQFWLRQVDVDKHDWVLQN
removing heat away from the monitor. The external surface of the
FDELQHW¿QQHGDUHDPXVWQRWEHFRYHUHGRUWKHDLUÀRZUHVWULFWHGLQ
anyway by enclosing the LCD monitor.
(CE42LH2WP model only)
The operating temperature range of this monitor is guaranteed 0°C
~ 40°C/32°F ~ 104°F. It is not recommended to install the screen
in direct sunlight without adequate shading, as this will cause the
WHPSHUDWXUHRIWKHSDQHOWRULVHDERYHWKHPD[LPXPVSHFL¿HG'R
-
LQJVRPD\FDXVHDEODFNVKDGRZWRDSSHDURQWKHVFUHHQZKLFK
will disappear when the screen temperature returns to within the
VSHFL¿FDWLRQ7KLV³RIFRXUVH´GRHVQRWSURGXFHDQ\KDUPIXOHIIHFW
on the lifetime of the monitor.
Do not
apply liquid cleaners or aerosol cleaners directly onto the LCD
monitor. Use a damp cloth for cleaning.
ADDITIONAL FOR NORTH AMERICA AND CANADA:
This
monitor must
NOT
be permanently mounted to the building
structure. It must be mounted in such a way that it can be removed
using basic tools.
The
power supply cord must
NOT
be attached to the building surface.
The power supply cord must
NOT
be routed through walls, ceiling,
ÀRRUVRURWKHUVLPLODURSHQLQJVLQWKHEXLOGLQJVWUXFWXUH
The
power supply cord
MUST
be positioned so as to prevent physical
damage.
Important: (UK only)
THIS PRODUCT MUST BE EARTHED.
7KLVHTXLSPHQWLV¿WWHGZLWKDQDSSURYHGPDLQVOHDGDQGDQ
approved non rewireable UK mains plug. To change a fuse in this
type of plug proceed as follows:
1.
Remove the fuse cover and fuse.
2.
Fit a new fuse which should be a BS1362 13 Amp A.S.T.A. or
BSI approved type.
3.
(QVXUHWKDWWKHIXVHFRYHULVFRUUHFWO\UH¿WWHG
If the fuse cover is lost or damaged the plug must
NOT
be used
but replaced with a serviceable plug.
,IWKH¿WWHGSOXJLVQRWVXLWDEOHIRU\RXUVRFNHWRXWOHWVLWVKRXOGEH
FXWRIIDQGDQDSSURSULDWHSOXJ¿WWHGLQLWVSODFH,IWKHPDLQVSOXJ
contains a fuse, this should have a rating of 13 Amp, ensure the
IXVHFRYHULVFRUUHFWO\¿WWHG,IDSOXJZLWKRXWDIXVHLVXVHGWKH
fuse at the distribution board should not be greater than 13 Amp.
Note:
The severed plug must be destroyed to avoid a possible
VKRFNKD]DUGVKRXOGLWEHLQVHUWHGLQWRD$PSVRFNHWHOVH
-
where.
The wires in this mains lead are coloured in accordance with the
following code:
Blue
Neutral
Brown
Live
Green and Yellow
Earth
1.
The Blue wire must be connected to the terminal which is
PDUNHGZLWKWKHOHWWHU³1´RUFRORXUHG%/$&.
2.
The Brown wire must be connected to the terminal with the
letter “L” or coloured RED.
3.
The Green and Yellow wire must be connected to the terminal
ZKLFKLVPDUNHGZLWKWKHOHWWHU³(´RUFRORXUHG*5((1RU
GREEN and YELLOW.
%HIRUHUHSODFLQJWKHSOXJFRYHUPDNHFHUWDLQWKDWWKHFRUGJULSLV
clamped over the sheath of the lead - not simply over the wires.
Do not
attempt to bypass the safety purpose of the grounding
type plug.
THIS UNIT IS NOT DISCONNECTED FROM THE MAINS UN-
LESS THE MAINS LEAD IS UNPLUGGED.
THE INSTALLER MUST MAKE SURE THE MAINS LEAD IS
EASILY ACCESSIBLE.
SAFETY PRECAUTIONS
GB
GB
