EXT. ANT
AM
LOOP
FM
ANT
PHONES
SPEAKERS
(4
Ω
MIN.)
R
L
EXT. ANT
AM
LOOP
FM
ANT
PHONES
SPEAKERS
(4
Ω
MIN.)
R
L
1
2
1
2
3
-E3-
SAFETY CERTIFICATION
This unit is made and tested to meet exacting safety standards. It
meets UL, CSA and FCC requirements and complies with safety
performance standards of the U.S. Department of Health and
Human Services.
CAUTION - USE OF CONTROLS OR ADJUSTMENTS OR PER-
FORMANCE OF PROCEDURES OTHER THAN THOSE SPECI-
FIED HEREIN MAY RESULT IN HAZARDOUS RADIATION
EXPOSURE.
THIS UNIT SHOULD NOT BE ADJUSTED OR REPAIRED BY ANY-
ONE EXCEPT PROPERLY QUALIFIED SERVICE PERSONNEL.
CAUTION:
Changes or modifications not expressly approved by Sanyo may
void the user’s authority to operate this equipment.
NOTE:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for
help.
NOTE:
To minimize noise...
•
Keep the speaker wires, power cord and all other system con-
nection cables away from the loop antenna.
•
Do not place the antenna close to the speaker.
CONNECTIONS
Antennas
FM antenna
The FM indoor antenna lead wire (see the back of the unit) is suffi-
cient to receive most local FM broadcasts.
Unwind the antenna lead wire, then extend it as straight as possible
and, while listening to the sound from the system, secure it in a
position where the best FM reception is found.
Screws (not supplied)
AM antenna
The AM loop antenna is sufficient to
receive most local AM broadcasts. As-
semble the loop antenna.
Unwind the antenna wires, then con-
nect them to the AM LOOP terminals.
Place the loop antenna in a position
which yields the best AM reception, or
attach it to a wall or other surface as
shown.
FCC INFORMATION
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
AWM-660/US Eng page
4/16/04, 5:40 PM
4
