CORRECTIVE ACTION
Insert the power plug into the AC outlet.
(See page E4.)
Turn up the volume. (See page E7.)
Select the correct function.
Connect the connector firmly to the speaker
terminals. (See page E4.)
Load the disc on the disc tray with the label
facing toward you. (See pages E8.)
Clean the disc. (See page E8.)
Replace the disc. (See page E8.)
1.
Press [
z
/ON] to turn the power off.
2.
While pressing [
N
] on the unit, press [
I
]
on the unit for at least 1 second.
3.
Press [
z
/ON] to turn the power on.
(See page E5.)
Change the reception frequency setting.
(See page E11.)
Press [FM MODE/REPEAT] to display
“MONO”. (See page E11.)
Reorient the FM antenna lead wire or install
an outodoor FM antenna. (See pages E3)
Clean the tape path. (See page E15.)
Place tape over the guard tabs. (See page
E12.)
SYMPTOM
No power when [
z
/ON ] is set to on.
No sound.
No sound from any function.
The CD player will not operate.
The sound from the CD player skips.
Abnormal CD or display operation with
the correct button settings.
Incorrect FM frequency.
Flickering “ST”.
Poor sound quality during playback.
Record mode does not operate.
POSSIBLE CAUSE
No power plug connection at the AC outlet.
Volume control is set to minimum.
The wrong function is selected.
Faulty speaker connections.
The disc is loaded with the label toward the unit.
The compact disc is dirty.
The compact disc is scratched.
The memory must be reset.
Incorrect reception frequency setting.
Weak signal.
Dirty heads, pinch roller or capstan.
The guard tabs have been removed from the cas-
sette.
WARNING:
FOR YOUR PERSONAL SAFETY, BE SURE TO DISCONNECT
THE AC POWER CORD BEFORE PROCEEDING WITH ANY
MAINTENANCE OR CLEANING.
Cleaning the cabinet
Use a clean soft cloth moistened with plain lukewarm water and
wrung dry. Never use benzol, benzene or other strong chemical
cleaners since these could damage the finish of your unit. It is im-
portant that no liquid reaches the inside of the unit.
Cleaning the CD player lens
The lens should never be touched. If dust is on the lens, blow it off
using a camera lens blower. (Consult your dealer.)
MAINTENANCE
Cleaning the tape heads and tape path
To ensure continued high performance, use a cleaning tape
(availabel from your local audio dealer) to clean the head block of
the deck after every 10 hours of use.
-E15-
TROUBLESHOOTING GUIDE
If you have followed the instructions and are having difficulty operation the unit, locate the SYMPTOM in the left column below. Check the
corresponding POSSIBLE CAUSE and CORRECTIVE ACTION columns to locate and remedy the problem.
SERVICING:
Should this product require service, refer to the SANYO audio limited warranty.
If you do not have a convenient SANYO service station nearby, contact the SANYO dealer where you purchased the unit. Be sure to give the
model number and explain the problem. The dealer will advise you how to obtain service.
AWM-660/US Eng page
4/16/04, 5:41 PM
16
