4
5
Step 1:
Step 2:
Step 3:
The washing machine should be placed inside a room with a flat floor, which is convenient for water supply
and drain, has low moisture and no direct sunshine, and does not freeze in winter.
All foam packing should be taken off, otherwise the washing machine will not work.
Horizontalize the washing machine according to the instructions below to make the washing machine run
steadily in low noise.
1.Loosen the FIXING POLE on the ADJUSTING FOOT, screw in or screw out the ADJUSTING FOOT to
make the four braces placed even on the floor. (the ADJUSTING FOOT is on the left front bottom of the
CABINET).
2.Check whether the washing machine is on a level surface using a plump line as shown in the below
Fugure.The washing machine is on level groud floor if the frame line is parallel with the plump line.( A=A',
B=B').
3.After the adjustment the FIXING POLE should be screwed back and tightened.
Notices:
o
If the washing machine is not placed flat (the inclination angle is over 2 ), it may cause excessive vibration,
automatic check and rectification or other abnormal circumstances will often take place in the course of
spinning.
Remove all foam packing including the FIXING FRAME on the BASE FOAM in the step 2.
Hole for Self-tapping screw
Slot
Base cover
Installation of the base cover
o
1. Slant the washing machine with angle of 45 in the direction of
the arrows showed in the figure. Slid the BASE COVER between
the SLOTS from the back side of the washing machine.
2. Put the BASE COVER straight to the point and then press it
upward till you hear it adjust, and
screw it.
CAUTION!
Carpet dose not obstruct the openings for washing machine with ventilation
openings in the base.
CAUTION!
If this appliance is supplied from a cord extention set or electrical portable outlet device,the cord extention set or
electrical portable outlet device must be positioned so that it is not subject to splashing or ingress of moisture.
Simple operation
1. Put detergent into WASH/SPIN TUB.
2. Put the POWER PLUG into the socket, switch on th power.
3. Open the tap.
4. Press "Power" button.
5. Press "Start/Pause" button. The washing machine will go into operation by the automatic program of standard.
"PROGRAMS".
Remark:
If you want to set other programs, please see and read
Power source
If the supply cord is damaged,it must be replaced by the manufacturer,its service agent or similarly qualified person in
order to avoid a hazard.
DRAIN HOSE must be placed at least 86cm (30inches) from the bottom of washer but not higher than 120cm.
P u m p m o d e l
Notice:
Drain hose blocke can lead to drain fault.
Plump
BASE FOAM
Screw in
Screw out
Loosen
ADJUSTING FOOT
FIXING POLE
Tighten
FIXING FRAME
