‑ 19 ‑
K.REMOVING DOOR
K.REMOVING DOOR
K.REMOVING DOOR
K.REMOVING DOOR
K.REMOVING DOOR
Remove 3 hex nuts securing the upper hinge,
remove 3 hex nuts securing the lower hinge
and remove 1 special screw securing the door
arm (located at the bottom of the door sash)
NOTES
‑ After replacing the door, be sure to check
that the primary interlock switch, the door
sensing switch and the interlock monitor
switch operate normally.
(See pages 1 and 8)
‑ After replacing the door, check for micro‑
wave energy leakage with a leakage detector.
Microwave energy leakage must be below the
limit of 5mW/cm
2
.
(1)Insert a thin flat blade screw driver
between the choke dielectric and the
door assembly comp.and lift up the
choke dielectric to release the hook
one by one.
(2)To remove door cover,remove the 14 screws
securing the door cover to the door
assembly comp.
(3)Remove 1 screw securing the cover as‑
sembly to the door assembly comp.
(Figure 23‑(a))
(4)Insert a thin flat blade screwdriver
between the door base and door as‑
sembly comp.and release the hook one
by one.
(5)To detach the cover assembly,insert
a thin flat blade screwdriver between
the door panel and door cover,and
release the clip one by one.
NOTES
The choke dielectric,the glass door
panel and the door cover may be dam‑
aged when they are removed. When re‑
installing the door in place,check
for microwave energy leakage with a
leakage detector. Microwave energy
leakage must be below the limit of
5mW/cm
2
.
Figure 23
Both sides tape
Cover assembly
Door base
Door handle
Ornament plate
Door cover
Door panel
Packing
Door assembly comp
.
Choke dielectric
Packing
Door arm
Latch sup.
Spring
Door latch
4x6
4x16
5x16
5x16
Remove 1 screw
securing the cover
assembly to the door
assembly comp.
(a)
L. DISASSEMBLY DOOR
L. DISASSEMBLY DOOR
L. DISASSEMBLY DOOR
L. DISASSEMBLY DOOR
L. DISASSEMBLY DOOR
