Sanwa SE9100, Instruction Manual

Page: 32 / 44

－ …28…－
5-3-2 Hold function (CH1/CH2)
– m/min & r/min measurements only
The current measurement value can be held on the CH1 display by
either pressing the CH1 button or using the CH1 external triggering
function. Similarly, the measurement value can also be held on
the CH2 display by means of the CH2 button or CH2 external
triggering. As CH1 and CH2 are independent functions to each
other, they are convenient for use in comparison of measurement
values.
To use external triggering, connect the provided external triggering
input cable (SE-L-H) to the instrument, set the red and black
alligator clips to open and hold the current measurement value.
Two input cables are required when using both CH1 and CH2.
5-3-3 Analog output function
When the provided analog output cable (SE-L-O type) is connected
to the OUTPUT jack of the instrument, the measurement value is
converted into a voltage and output there. (See “Analog output full
scale setting” in section 5-2, “Settings”.)
5-3-4 Memory function
When the SAVE button is pressed in the measurement mode, the
held values and maximum values currently displayed for CH1/CH2
are saved as a set in the memory of this instrument. At this time,
the memory No. is shown on the CH2 display.
Saved in memory No.3
0.5 sec. after
Measurement mode
To recall the saved data, press the MENU button to enter the
setting mode and then press the ENT button three times. The CH1
display shows [ ] to indicate that the memory can be recalled.
If data is saved in the memory, the memory No. is shown on the
CH2 display.