4) Relative measurement switch (RELATIVE)
Suppose that actual value is X1 when REL switch is pressed. Then,
value of X-X1 is displayed for actual input value X after that. Each time
pressing REL switch, value of X1 is updated. This function is except
the Hz/DUTY measurement mode.
＜
In the case of use at the DCV and ACV function
＞
・
In the case of canceled, please push the switch again.
・
The measurement range is fixed to the range in the point that pushed
the switch. About measurement after this, the range is fixed. To
return to the auto range, please stop measurement once and set the
function again.
・
Do not measure any signal that exceeds the maximum of current range.
＜
In the case of use
Ω、
、
function
＞
・
When O.L is displayed, setting and cancellation are not possible.
・
In the case of canceled, please push the switch again.
・
The resistance measurement range is fixed to the range in the point
that pushed the switch. About measurement after this, the range is
fixed. To return to the auto range, please stop measurement once
and set the function again.
＜
In the case of use
function
＞
・
In the case of canceled, please push the switch again.
・
The Capacitance measurement is auto range mode only. After canceled
relative mode, it is possible measurement with the auto range.
5) Hz/DUTY (Frequency/Duty)switch
This switch uses it for the switching of Hz/DUTY. In the case of the
mode change as Hz
→
DUTY
→
voltage measuring mode
→
Hz.
●
When it returns it to the voltage function after the Hz/DUTY
measurement the range is fixed automatically. (DCV function is
400mV. ACV function is 4V.) Please stop measurement once to
cancel the manual range. And please do measurement after the
function is set up again.
6) Auto power off
This equipment incorporates an auto power off which turns off the
display in about 15 minutes to save power. If you want to continue to
use the equipment, press the SELECT switch. To cancel auto power
off for long time measurement, turn function switch from OFF position
to position of desired function while holding down SELECT switch.
Then release SELECT switch approx. 2sec. to 3sec. after.
ー 4 ー