SANUSLIFE ECAIA S, Operating Instructions Manual

Page: 6 / 14

7 6
13
C
C C C C
4 Installation of ECAIA ionizer S+ and ECAIA ionizer S faucet
4.1 Permanent connection to the angle valve (ECAIA ionizer S+;
appliance in below counter position)
Compare table E (page 3).
The ECAIA ionizer S+ can be permanently connected to the angle valve under the
sink, as described under point “1.4 - Permanent connection to the angle valve (appli-
ance in above-counter position)”. Due to the positioning of the device under the sink,
it must be operated using the special ECAIA ionizer S faucet.
1. Install the T-piece (A-10) on the angle valve of
the cold water pipe. If necessary, the cold water
supply pipe to the faucet must be disconnected
and connected with the T-piece in between.
CAUTION:
When assembling please make sure
the connection pins on the T-piece do not bend
sideways. This may cause a micro crack, which
can even lead to breakage due to the constant
water pressure.
2. Verbinden Sie den Trinkwasser-Zulauf-
schlauch (A-6) mit der Schnellverschluss-
Öffnung am T-Stück (A-10) und fixieren
Sie den Sicherheitsstift 1/4” (C-6).
3. Connect the other end of the tap water supply hose (A-6) to the filter for the 1/4”
tap water supply hose (C-14) (note the flow direction!). Use 5 cm of the tap water
supply hose (A-6) to connect the filter for the 1/4” tap water supply hose (C-14)
and the water pressure reducing valve (C-13) (note the flow direction!). Use 5
cm of the tap water supply hose (A-6) to connect the water pressure reducing
valve (C-13) and the solenoid valve(C-12) (note the flow direction!). Use 20 cm
of the tap water supply hose (A-6) to connect the solenoid valve (C-12) to the