32
ESPAÑOL
1. Encuentre un clavo/tornillo en el montante con el detector magnético de bordes de montantes Sanus
12
incluido.
2. Encuentre los bordes del montante con el detector magnético de bordes de montante
12
.
3. Marque el centro del montante con un lápiz.
4. Coloque la plantilla de placa mural
10
a la altura que desee y posicione los orificios intermedios sobre las líneas centrales del montante.
Nivele la plantilla de la placa mural
10
y fíjela con cinta adhesiva en el lugar.
NOTA:
Si necesita ayuda para determinar la ubicación de la placa mural, utilice la herramienta HeightFinder disponible en sanus.com.
IMPORTANTE
:
Asegúrese de marcar y perforar el centro del montante.
5. Haga los dos orificios guía intermedios (en el montante) con una mecha de 5,5 mm (7/32") de diámetro.
IMPORTANTE
:
Los orificios guía deben realizarse hasta una profundidad de 89 mm (3 1/2").
Haga los dos orificios guía superiores externos (en el tabique de yeso) con una mecha de 10 mm (3/8") de diámetro.
IMPORTANTE
:
Los orificios guía deben realizarse hasta una profundidad de 25 mm (1").
6. Retire la plantilla de la placa mural
10
e inserte dos anclajes
14
en los orificios superiores externos.
PRECAUCIÓN:
Cerciórese de que los anclajes
14
queden nivelados respecto de la superficie de yeso.
7. Coloque parcialmente los dos pernos tirafondo superiores
13
en los anclajes
14
, dejando aproximadamente 13 mm (1/2") de espacio
desde la pared.
NOTA:
Este espacio le permite colgar la placa mural
11
en los pernos superiores
13
.
8. Deslice las cubiertas abiertas sobre la placa mural
11
para que los orificios de montaje queden expuestos.
9. Cuelgue la placa mural
11
sobre los pernos superiores
13
.
10. Coloque los dos pernos tirafondo intermedios
13
. Ajuste los cuatro tornillos tirafondo solamente hasta que queden firmes contra
13
la
placa mural
11
.
NOTA:
Sostenga la placa mural
11
en su lugar mientras ajusta el primer perno
13
para evitar que se mueva fuera de su sitio.
PRECAUCIÓN:
El uso indebido podría reducir la capacidad de retención de los tornillos tirafondo
13
. NO ajuste en exceso los
tornillos tirafondo.
11. Deslice las cubiertas cerradas sobre la placa mural
11
.
Continúe con el PASO 3 en la PÁGINA 21.
*
ADVERTENCIA
:
Este producto contiene un imán. Si utiliza un dispositivo médico implantado como un marcapasos o un desfibrilador automático
implantable (DAI), los campos magnéticos pueden afectar el funcionamiento de esos dispositivos y causar heridas de gravedad o la muerte. Si tiene
un dispositivo médico implantado, mantenga una distancia de al menos 13 cm (5 pulgadas) entre su dispositivo y el imán. Consulte a su médico antes
de utilizar este producto.
Summary of Contents for VMT5
Page 27: ...27 ...