Santerno ASAB, Instructions Manual

Page: 8 / 12

2/6 USB Module
1. Important User Information
Observe all necessary safety precautions when controlling the soft starter remotely. Alert personnel that machinery may start without
warning.
It is the installer's responsibility to follow all instructions in this manual and to follow correct electrical practice.
2. Introduction
The USB Module can be used in conjunction with WinMaster to manage Santerno soft starters.
These instructions detail the installation, set-up and configuration of the USB Module. For details on using WinMaster, refer to the
WinMaster help file.
NOTE
For WinMaster to communicate with a soft starter via the USB Module, WinMaster must be configured to use the AP
ASCII or AP Binary protocols.
3. Installation
CAUTION
Remove mains and control voltage from the soft starter before attaching or removing accessories. Failure to do so may
damage the equipment.
3.1 Physical installation
1. Fully pull out the top and bottom retaining clips on the module.
2. Line up the module with the comms port slot.
3. Push in the top and bottom retaining clips to secure the module to the starter.
1 2 3
1
0
1
7
8
.B
Remove the module using the following procedure:
1.
Remove control power and mains supply from the soft starter.
2. Take the module off-line.
3. Disconnect the USB cable from the module.
4. Fully pull out the top and bottom retaining clips on the module.
5. Pull the module away from the soft starter.