5
3) For C10K(e)/C10KS(e) UPS, it is recommended to select the UL1015
8AWG(10mm
2
) wire or other insulated wire which complies with
AWG Standard for the UPS input and output wirings.
Note: Do not use the wall receptacle as the input power source for the
UPS, as its rated current is less than the UPS’
s maximum input
current. Otherwise the receptacle may be burned and destroyed.
4) Connect the input and output wires to the corresponding input and
output terminals according to the following diagram.
Note: you must make sure that the input and output wires and the input
and output terminals are connected tightly.
5) The protective earth ground wire refers to the wire connection be-
tween the equipment which consumes electro-equipment and the
ground wire. The wire diameter of protective earth ground wire should
be at least as above mentioned for each model and green wire or
green wire with yellow ribbon wire is used.
6)
7) Please install the leak current protective breaker at the output power
distribution panel of the UPS if necessary.
8) To connect the load with the UPS, please turn off all the loads first,
then perform the connection and finally turn on the loads one by one.
9) No matter the UPS is connected to the utility power or not, the output
of the UPS may have electricity. The parts inside the unit may still
have hazardous voltage after turning off the UPS. To make the UPS
have no output, power off the UPS, and then disconnect the utility
power supply.
10) Suggest charging the batteries for 8 hours before use. After
connection, turn the input breaker in the “ON” position, the UPS will
charge the batteries automatically. You can also use the UPS im-
mediately without charging the batteries first, but the backup time
may be less than the standard value.
11) If it is necessary to connect the inductance load such as a monitor
or a laser printer to the UPS, the start-up power should be used for
calculating the capacity of the UPS, as its start-up power consump-
tion is too big when it is started.
After having completed the installation, make sure the wiring is correct.
2. Installation
