SBIG ST-8300 Manual
9. If for some reason the
Add New Hardware Wizard
asks you to
manually locate the drivers then navigate to the proper directory under
the Driver Checker directory in the
Program Files
or
Program Files
(X86
) directory. There are 4 possibilities and you must choose the
correct set of drivers. There are directories for 32 Bit and 64 Bit
drivers, based upon you version of Windows and under them
directories for Classic and Pro model cameras.
10. At this point the fan in the camera should come on and the camera
should show up in the Device Manager as shown below:
11. Run CCDOps and verify that you can establish a link to the camera.
Note: If you previously installed SBIG 32-bit drivers using the old 32-
bit Driver Checker program and now want to install 64-bit drivers
over the old installation, follow the procedure outlined below:
Migrating Old Drivers from 32-bit to newer 64-bit Systems
This section describes how to migrate drivers from the old 32-bit only
DriverChecker
to the new 32/64-Bit Compatible
DriverChecker64
.
1. Uninstall the old DriverChecker software.
a.
Run the
Add or Remove Programs
Control Panel in the
Start menu.
b.
Click on the
SBIG Driver Checker
entry and then click
on the Change/Remove button.
2. Manually delete the old drivers files from the disk.
a.
Delete the following files from the
C:\Windows\System32\Drivers directory:
sbigfldr.sys
,
sbiguldr.sys
,
sbiglldr.sys
,
sbigusbe.sys
,
sbigusbi.sys
Some of these may not exist on your system but delete the
ones that do.
10
Summary of Contents for ST-8300C
Page 48: ...SBIG ST 8300 Manual 45...
