JCD3007
4
BLACK
REAR PRE-AMPLIFIER LINE OUT COMMON
RED
RIGHT REAR PRE-AMPLIFIER LINE OUT
WHITE
LEFT FRONT SPEAKER (+)
WHITE/BLACK
LEFT FRONT SPEAKER (-)
BLUE
POWER ANTENNA
RED
IGNITION (ACC)
BLACK
CHASSIS GROUND
WHITE
LEFT REAR PRE-AMPLIFIER LINE OUT
Power Antenna
Connect to power antenna or amplifier, If not used, tape bare end of wire.
Ground
Connect to ground terminal or clean unpainted metal part of chassis.
Accessory/Ignition
Connect to existing radio wire or radio fuse.
LEFT FRONT
LEFT REAR
RIGHT FRONT
RIGHT REAR
VIOLET/BLACK
BASIC OPERATION
Power On/Off ( )
Press the button (1) to turn the unit ON or OFF.
Volume Control
To increase the volume, press the
VOLUME /\
button (4). To decrease the volume, press the
VOLUME \/
(6) button.
When the volume is adjusted, the volume level is shown on the display panel as a number ranging from 00 (lowest) to 100 (highest).
Mute
Press the
MUTE
button (8) on the control panel (or the
MUT
button on the remote control) to
mute the audio output. “Mute” will appear on the
display. Press
MUTE
again to restore the audio output to the previous level.
Mode
Press the
MODE
button (5) on the control panel to select a different mode of operation, as indicated on the display panel. Available modes
include Radio, CD, and AUX In (optional Auxiliary Input).
Auxiliary Input
1.
Connect the external signal to the “Aux In” jack (20) located on the front of the control panel.
2.
Press the
MODE
button to select Aux In mode.
3.
Press
MODE
again to cancel Aux In mode and return to previous mode.
Reset
After releasing the control panel, use a pencil or any non-metallic object to
press and hold
the
RESET
button (17) for five seconds to reset the
main unit. The unit will return to the factory default settings. The reset button should be activated for the following reasons:
•
initial installation of the unit when all wiring is completed
•
function buttons do not operate
