Maintenance
Protection of wood
Brush each exterior barrel slat and apply a wood stain when full assembly to protect the wood.
This wood stain had to be renewed according to the recommendations of the product used
Maintenance
IMPORTANT :
Disconnect the cabin’s power supply cable before undertaking any work.
Problems identified
Possible reasons
Solutions
Electric stove does not heat up.
Power supply cable disconnected.
Check power supply cable connection.
The general power supply is cut.
Check that the switchboard and wall plug
are working.
Stove is overheat protected.
Refer to the electric stove manual.
Sauna light fitting no longer
work.
Light cable not fully plug.
Plug the cable.
Light is defective.
Contact your dealer.
Servicing
1. Disconnect your sauna.
2. Use a vacuum cleaner to remove dust from crevices in the woodwork.
3. Clean the cabin with a damp cotton cloth and use a small amount of soap if necessary. Rinse with a damp cloth.
4. Clean the glass with a window / glass cleaner and a soft colth.
5. Maintain the exterior of the sauna every 2 years with a suitable product.
IMPORTANT :
The wood should be treated with a protective product only on the outside of the sauna.
No treatment should be applied inside the sauna.
Do not use benzene, alcohol, chemical agents or strong detergents on the sauna since chemical products can damage the
wood. Do not spray water on your sauna.
Please read the instructions provided with the sauna stove for the installation and use of the stove.
The heater may only be connected to the electrical network in accordance with the current regulations by an authorised,
professional electrician.
Summary of Contents for LAHTI
Page 4: ...Description sauna...
