2. PERIODIC MAINTENANCE
2-15
Unscrew bleed screws on top of thermostat housing.
Both cylinders must be bled.
Fill up the radiator with coolant, when the coolant
comes out by the thermostat housing hole, install the
bleed screws with its gasket ring and torque to 10 N.m.
Refill coolant tank up to upper level mark. Install the
coolant tank cap and the radiator cap.
Run engine until radiator fan opens then stop engine.
When engine has completely cooled down, recheck
coolant level in radiator and coolant tank, Top up if
necessary
WHEELS
Lift wheels up at horizontal position and ensure no
load to each wheel.
Shake wheels to left and right to see whether their
connecting parts are installed tightly and check whether
they can be swung.
No adequate tightening: → tightening
Swing: → replace rocker arm
Tire pressure
Improper tire pressure will lower comfort of operation and driving and may lead to wear to side edges of tires.
Front wheel
Rear wheel
Rated pressure
62kPa(0.62kgf/cm
2
) 62kPa(0.62kgf/cm
2
)
Dimension of tire 26×9-14
26×11-14