9
3
ASSEMBLY
3-1. INSTALLING STANDS AND RETURN ROLLERS
1. Place conveyor frame upside down on table. (Assembly is easier this way.)
2. Install inverter unit delivered in separa
te packaging. → See p.1
3. (For constant-speed type using 200V
three-phase power source, controller is optional.)
3. If return rollers are delivered in separate packaging, stickers RETURN ROLLER FIXING POSITION are
affixed on side of frame. Return roller attachment tap pieces are temporarily bolted into frame
underside slots, just under the stickers. Install return rollers using the tap pieces as shown in figures
below. (Return rollers are individually packed and temporarily attached beside drive unit.)
NOTE: 1. For center drive type of 2m or less in length, machine has no return roller.
2. In the following cases, return rollers are delivered already installed as shown in figure below left, i.e.
installation is unnecessary.
-3m or less in machine length and 60mm in frame depth
-3m or less in machine length, 30mm in frame depth and 300mm or less in belt width
4. Stands(optional) are delivered in separate packaging. Install them using the attached stand tap pieces.
NOTE: 1. Install each stand in appropriate position referring to “Standard Installation Positions of Stands”,
p.10.
2. For machine length of 1.2m or less, stand tap pieces are delivered inserted into conveyor frame.
Installation will become easier by inserting
and tightening bolt into end of tap piece.
5. When assembly is complete, turn over the entire conveyor and place on the floor.
