SANKI MFC-S3B-F, Instruction Manual

Page: 26 / 36

24 / 32
10. “io” Mode Setting Function
This Controller can switch the control target of the overflow sensor input [in2 Input].
The functions that the “io” mode setting can perform:
① Switching of the “ io ” mode
② Initialization of the set data [Reset to the factory setting]
Function Control target
io01
Controls the feeder output in [in2 Input]. [with overflow stop] (factory setting)
io02 Does not control the feeder output in [in2 Input]. [without overflow stop]
99 Initializes the set data [Resets to the factory setting].
1)
“io” mode switching method
(1) When the power supply to the Controller is OFF, power ON the Controller by pressing both
the Vol ▲ key and the Freq ▼ key together.
(2) The data display area displays “io01” to start the Controller.
※ If the Controller starts in a normal manner, redo the above (1) and (2).
(3) Press the Freq ▲ key to select the “ io ” mode to be used.
The display switches “ io01 ” → “ io02 ” → “ 99 ” → “ io01 ” in this order.
When the Freq ▼ key is pressed, the display area switches them in the reverse order.
(4) Press the Set key long for 2 sec to start the controller in a normal manner in the selected “io”
mode.
For example, when “io02” is selected, “io02” is displayed when the “io” mode is displayed
upon powering ON the controller.
※ The motion in each “ io ” mode is identical to the motion shown in the following time chart:
① When the “ io ” mode is “ io01 ” ② When the “ io ” mode is “ io02 ”
Feeder output
When the “io” mode is “ io02 ” , the parameter
Nos. 0E and 0F become invalid.
Feeder output