SaniSeat SS-101, Installation & Service Manual

Page: 16 / 27

Mounting the Sani Seat to the toilet bowl
All hardware needed to mount the
Sani Seat
to the toilet bowl can be found in the wall
sensor box. You will find two metal plates, two 1
1
/
2
'' bolts with tapered and regular washers,
and
9
/
16
'' nuts. You will also find the keys for the locking lid, yellow nylon anchors and
screws, however you will not need them until later in the installation process when mounting
the Wall Sensor and gang plate to the wall.
1. The original seat should be removed leaving
just the porcelain bowl.
5. Take the two 1
1
/
2
'' bolts and place them
through the metal plate slots and in the bowl's
bolt holes.
2. Place the
Sani Seat
on the bowl so that the
metal bracket is over the boltholes.
6. In one hand hold a tapered and metal washer,
along with a
9
/
16
'' nut.
3. Take both metal plates from the sensor box
and lift seat so bracket is easily visible.
7.
4. Place the metal plates in the bracket channel
so the bolt holes are visible.
Before threading arrangement onto the bolt,
keep constant downward pressure on the bolt.
NOTE: The plastic washer should be against
porcelain.
Page 10