Cleaning
All surface should be cleaned using a clean damp cloth. No abrasive
cleaning agents or materials should be used.
Once the surrounding finishes have been applied (Tiles/Marble etc.) remove the
protection covers. Fit the face plate onto the mixer body, it is advised to use a
small amount of lubricant on the rubber seals. Slide the handle onto the cartridge
pin and secure with the grub screw, then push on the cover cap.
Open the water supplies and re-test for leaks.
• Before making any inlet pipe connections, all supply pipes MUST be thoroughly
flushed to remove debris. Failure to do this could result in damage to the
cartridge and components or low flow from the mixer'
Summary of Contents for AQUAECO AQM-EX3-410-BS
Page 2: ......
Page 6: ...Note...
Page 7: ...Note...
Page 8: ...INM EX3 410 BS 11 21 www sanipexgroup com AQUAECO WASHROOM AND PLUMBING SOLUTIONS...
