Power - DC Power connector.
E1/T1 Port 1-2 - RJ45 port used to connect your E1/T1 Cable
LAN Port 1/LAN Port 2 - RJ45 ports used to connect your LAN cables. These are Gigabit compatible ports.
Console - Used for diagnostics. Console cable plugs into this port
Find Below the Default pinout configuration:
Port 1 (CPE/Te)
Port 2 (NET/NT)
Pin
Signal
1
RxRing
2
RxTIP
4
TxRing
5
TxTIP
Pin
Signal
1
TxRing
2
TxTIP
4
RxRing
5
RxTIP
Vega 400G
Front Panel of Vega 400G
Back Panel of Vega 400G
Port 1 is configured for CPE/TE. This port is typically connected to Telco as it is set to receive the clock from the remote
side
Port 2 is configured for NET/NT. This port generating clock signal and is typical connected to another PBX
If you wish to change the configure of the ports (i.e. port 1:NET/NT or port 2: CPE/TE) you must connect a cross-over
cable. (there is no software configurable pin-switching)
