1.
2.
1.
2.
3.
PBXact System 300 Recovery
The following steps will guide you through the re-installation process of your System 300 Sangoma appliance
Preparation
USB Recovery Process
Final Steps
Preparation
Verify that the appliance is powered off.
Connect the appliance to the internet using a LAN cable (The system requires internet to setup timezone and network details)
Plug a network cable (cat 5) into
on the appliance as seen below:
port 0
Plug the other end of the network cable into a network that will provide internet access to the appliance
Plug a USB-to-Serial Console Cable into the Console Port located on the front of the appliance, as seen below:
If you have a FreePBX appliance,
is labeled with a Green color instead of Grey as indicated above
Port 0
The System 300 does not come shipped with a USB-to-Serial Console cable. However, it is the standard console cable that is
used with any networking equipment.
See the below image for an example usb-to-seial console cable:
