03
GB
1. IMPORTANT SAFETY INSTRUCTIONS
1.
Do not install near any heat sources such as radiators,
heat registers, stoves or other apparatus (including
amplifiers) that produce heat.
2.
Only use attachments / accessories specified by the
manufacturer.
3.
To reduce the risk of fire or electric shock, do not
expose this appliance to rain or moisture.
4.
Apparatus shall not be exposed to dripping or
splashing liquids and no objects filled with liquids,
shall not be placed on the apparatus.
5.
The batteries shall not be exposed to excessive heat
such as sunshine, fire or the like.
6.
Any changes or modifications not expressly approved
by the party responsible for compliance could void the
user’s authority to operate the equipment and warranty.
7.
CAUTION:
Risk of explosion if the battery is replaced
by an incorrect type.
8.
Do not allow your radio to be exposed to water, steam
or sand.
9.
Do not leave your radio where
excessive heat could cause damage.
10.
The following safety relevant information should be
considered as applicable:
●
minimum distances around the apparatus for
sufficient ventilation;
●
the ventilation should not be impeded by covering
the ventilation openings with items, such as
newspaper, table-cloths, curtains, etc.;
●
no naked flame sources, such as lighted candles,
should be placed on the apparatus;
●
attention should be drawn to the environmental
aspects of battery disposal;
●
the use of apparatus in tropical and / or moderate
climates.
11.
CAUTION:
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent type.
12.
If an apparatus is provided with a replaceable lithium
battery, the following applies:
●
if the battery is intended to be replaced by the user,
there shall be a warning close to the battery or in
both the instruction for use and service instructions.
For United States:
Cautions to the user
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation.
Any Changes or modifications not expressly approved by
the party responsible for compliance could void the user’s
authority to operate the equipment.
Note:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
●
Reorient or relocate the receiving antenna.
●
Increase the separation between the equipment and
receiver.
●
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
●
Consult the dealer or an experienced radio / TV
technician for help.
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum
distance 20cm (8 inches) between the radiator & your
body.
2. Introduction
Overview of the main unit
1
FM antenna
●
Position and extend the antenna correctly to
improve the radio's FM reception.
2
Speaker
3
LCD display
4
Up button
●
Press to navigate in the radio's menus or change
the current character while inputting text.
●
While in FM mode, press to increase the frequency.
●
While playing from a UPnP server, press to go to
the previous track.
5
Right button
●
Press to navigate in the radio's menus or select
the next character while inputting text.
●
While in FM mode, press to increase the frequency.
●
While in FM mode, press and hold to automatically
scan from the current frequency for a station with a
higher frequency.
●
While playing from a UPnP server, press to watch
track cover.
●
While playing from a UPnP server, press and hold
to go to the next track.
6
Power button
●
When connected to a USB power source, press
this button to turn on the radio or switch to the
Standby mode.
●
When not connected to a USB power source,
press this button to turn the radio on or off.