Sangean RCR-10, Manual

Page: 30 / 191

29
4. Rotate the Tuning control to choose the required alarm type,
and then press and release the Tuning control to confirm
the setting. The alarm can be set to buzzer, iPod, FM or AM.
When radio mode is selected, the radio frequency and the preset
number on the display will begin to flash. Rotate the Tuning control
to adjust the required radio frequency or the required preset
number for the radio alarm, then press and release the Tuning
control to confirm the setting.
Note:
If the alarm type selected is iPod but your iPod is not
docked when the alarm is sounding, the buzzer alarm will
be used instead.
5. Rotate the Tuning control to choose the required sound level for
the alarm. Press and release the Tuning control to confirm
the setting.
6. The alarm has now been set. Press and release the Tuning
control again, and the radio will revert to normal display.
Active alarms are shown using alarm indicator on the display.
When the alarm sounds
To cancel a sounding alarm, press and hold the Alarm 1 or Alarm 2
button until the alarm indicator on the display disappears.
When the buzzer alarm activates, the alarm will start softly and
gradually increase in level. It will sound for 1 minute and silence for
1 minute in repetition for 60 minutes unless cancelled. The radio will
sound non-stop at the selected time for up to 60 minutes for other
alarm types.