04
GB
F
E
NL
D
Antenna / Earphone
Insert the earphone into the earphone jack. The cord connecting the earphone to the receiver
acts as an antenna during FM audio reception and should be extended as much as possible to
increase the sensitivity.
A built-in ferrite bar antenna is provided for AM reception, it is only necessary to rotate the radio
for maximum signal strength during AM listening.
NOTE
When listening to the radio with an external power supply (e.g. AC power adaptor (not included)
or USB power cable), it may affect the listening quality while listening to the AM band.
NOTE
When the radio volume is adjusted to 19, there will be a beep sound indicating
that the current volume is too high. Excessive sound pressure from earphones and
headphones can cause hearing loss. To prevent possible hearing damage, do not
listen at high volume levels for long periods.
Volume Control
Use the Volume up / down button to adjust volume level. Display will show the changes when you
operate the volume buttons.
90 Minutes auto shut off feature
For saving battery power, this radio is designed to auto shut off after 90 minutes of operation.
The LCD display will show
icon when pressing the Power button to turn on the radio.
For continuous listening if necessary, press and hold the Power button for more than 2 seconds
when the radio is in power off mode. The
icon will disappear.
Scan Tuning
Turn on the radio, select the required band by pressing the Band button. Press in the jog wheel
to commence the scan tuning. The radio will scan and stop automatically when a station is found.
Manual Tuning
Turn on the radio, select the required band by pressing the Band button. Desired station may be
selected by turning the jog wheel up / down repeatedly until the desired station is reached.
Presetting stations
The radio has 20 memory presets each for FM and AM radio.
1.
With your radio switched on, select required band by pressing Band button.
2.
Tune to the required radio station as previously described.
3.
To store the station as a preset, press the Page button to select the required preset page
1 to 5 and then press and hold the required preset button (1-4) until you hear a beep (via
earphone) and the display will show the page and the memory pre-set you selected.
e.g. “
”.
Summary of Contents for DT-140
Page 1: ...Version 1 GB DT 140...
