Page 14 of 28
Transmitter. If the user chooses to use the lock, please refer to the
below part of lock installation. Security Lock and Transmitter
should be installed at same time.
3.
Screw the transmitter onto the tire valve.
4. Check the connection of Transmitter and valve with the soap solution
to confirm whether the transmitter is firmly screwed onto the valve or
not, check whether there is air leakage caused by the installation or the
seal of the Transmitters or not.
5. Once screwed onto the tire, transmitter can sense the pressure inside
the tire and transmit the data to the monitor, and the information will
appear on the screen within 6 minutes.
Note: 1. Please set the standards pressure of each tire on monitor
before install the transmitter. The standard pressure has
been set to100PSI in factory.
2. If one of your transmitters is broken or lost, the user only
needs to replace this one, the others will work as normal.
2. Installation of Security Lock
Each transmitter has a security lock and wrench to prevent it becomes
loose or falls off. The security lock has 3 screw holes and each one has 1
screw. As shown below:
