TPMS1209C01 User Manual
Page 23 of 23
batteries or connect the Monitor Display to the vehicle power through a 12V Lighter Plug
immediately.
Q: Why does the pressure inside the tire rise after running for some time?
A: This is because of the friction between the tires and the ground. Heat from the friction of a moving
tire will cause pressure inside the tire to rise. The pressure inside a tire can fluctuate up or down
approximately 2-4psi depending on the speed of the vehicle. This is normal for most vehicles.
Q: Why is the Monitor Display not turning on?
A: If the Monitor Display is being powered by batteries, please check whether the batteries are
installed in the correct polarity and if batteries have enough power. If the Monitor is powered by the
12V Lighter Plug, please check the connection between the Lighter Plug and your TPMS unit.
XIII. Warranty Terms
Valid Warranty Card
1. The Warranty Card must be filled completely, signed by the user and
the authorized distributors of S&T TPMS.
2. The Warranty Card is valid in the countries or regions where the purchase occurs.
3. The Warranty Service requires user to offer the Warranty Card.
Warranty Condition, Responsibility and Limitation
1. The product warranty period is one year and is subject to the time marked on the invoice.
2. Any damage or faults due to improper use are not involved in the warranty commitment.
3. User is not allowed to open, repair and refit the products by themselves, otherwise the warranty service
will be invalid.
4. The warranty does not include replacement of the enclosure and display panel.
5. The warranty does not cover product damage due to abrasion and corrosion.
XIV. Important Notes
1. The Warranty Card must be filled completely and its number shall be quoted whenever the user requires
the service.
2. Please inform Sate in the case that the telephone number or address on the Warrant Card is changed.
3. The warranty responsibility is subject to the conditions and limitations specified in the
User Manual.
FCC WARNING
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
NOTE: The manufacturer is not responsible for and radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s authority
to operate the equipment.
