S&T Kontron KBox B-201, User Manual

Page: 28 / 65

KBox B-201 - User Guide, Rev. 1.3
www.kontron.com // 28
6.2.1. Installing and Removing External 2.5” SSD
To install a 2.5” SSD, perform the following:
1. Open the SDD drive bay cover by following the instructions in Chapter 6.2: Opening and Closing SSD Drive Bay
Cover, steps 1 to 6.
2. Position the 2.5” SSD on the two ESD strips ( Figure 13 ) in the SSD drive bay with the SSD’s connector facing the
internal SATA connector.
Figure 13: SSD Drive Bay with SSD
3. Align the SSD’s connector with the internal SATA connector.
4. Press down on the SSD and gently push the SSD into the SATA connector.
5. Close the SSD drive bay cover by, proceeding as described Chapter 6.2: Opening and Closing SSD Drive Bay
Cover , step 7.
After installing or removing a 2.5” SSD, the partitioning of the memory maybe different.
To remove a 2.5” SSD, perform the following:
1. Open the SSD drive bay cover by follow the instructions in Chapter 6.2: Opening and Closing SSD Drive Bay
Cover, steps 1 to 6.
2. Hold the sides of the SSD and pulling out the SDD from the internal SATA connector carefully.
3. If the SSD does not release easily, move the SDD slightly from side to side while gently pulling out the SSD
from the SATA connector.
4.
To install a new SDD, proceed as described in Chapter 6.2.1: Installing and Removing External 2.5” SSD ,
steps 2 to 4.
5. Close the SSD drive bay cover by, proceeding as described in Chapter 6.2: Opening and Closing SSD Drive Bay
Cover , step 7.
After installing or removing a 2.5” SSD, the partitioning of the memory maybe different.
ESD strips