KBox B-201 - User Guide, Rev. 1.3
// 27
6.2.
Opening and Closing SSD Drive Bay Cover
Before opening the SSD drive bay cover pay attention to the safety instructions at the start of this chapter.
Before installing a 2.5” SSD, observe the manufacturer’s instructions.
To open the SSD drive bay cover, perform the following:
1.
Close all applications. Shut down the product properly and disconnect the power cable from the power
source. Disconnect all peripherals.
2.
Place the KBox B-201 on a flat, clean and ESD-safe surface with the bottom side facing upwards.
3.
Using a torx screwdriver (08 x 60), remove the screw that secures the SSD drive bay cover (Figure 8, pos. 3).
4.
Lift the SSD drive bay cover a few centimeters to release the SSD from SSD holding-plate on the rear side of
the SSD drive bay cover (Figure 11).
Figure 11: SSD Drive Bay Cover Rear Side
5.
Slide the SSD drive bay cover forward, to release the two aligning tabs (Figure 12).
Figure 12: SSD Drive Bay Cover Top Side
6.
Lift to remove the SSD drive bay cover.
7.
To close the SSD drive bay cover, proceed in the reverse order of steps 3 to 6.
To avoid damaging the SSD drive do not force when closing the SSD drive bay cover
When closing the SSD drive bay cover do not use force. If the cover does not close easily, the
metal SSD holding-plate on the rear side may not be aligned correctly and press on the SSD.
SSD holding-plate
Aligning tabs