INSTALLATION
GB
13
Cleaning Before Use
Wipe the inside of the unit with a weak solution of bicarbonate soda. Then rinse with warm
water using a ‘wrung-out’ sponge or cloth. Wipe completely dry before replacing the shelves
and bottle rack. Clean the exterior of the unit with a damp cloth.
If you require more information refer to the Cleaning section.
• Before Plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with
the unit.
• Before Turning On!
Do not turn on until two hours after moving the unit. The coolant fluid needs
time to settle.
Before Using Your Unit
Before placing any wine in the unit, turn it on and wait for 24 hours, to make sure it is
working properly and to allow it time to fall to the correct temperature. Your unit should not
be overfilled.
Location
When selecting a position for your unit make sure the floor is flat and firm, and that the room
is well ventilated with an average room temperature of between 16°C and 25°C. Placing the
unit in an environment out of this temperature range may affect the cooling performance,
designed storage temperature range 8°C - 18°C may not be reached. Avoid locating your unit
near a heat source, e.g. a cooker, boiler or radiator. Avoid direct sunlight.
Levelling the Unit
To do this adjust the levelling feet of the unit. If the unit is not
level, the doors and magnetic seal alignments will not be covered
properly.
Free Space Requirements
When installing the unit, ensure that 25 mm
of free space is left at both sides, 50 mm at
the rear of the unit and 25 mm at the top of
the unit. Please ensure there is more than
twice the width and depth distance space of
the unit to fully open the door to a maximum
angle of 160°.
Max. 160°
Y mm
X mm
SWC8B1T16E_IB_5L_RC_161103_grace.indb 13
3/11/16 4:15 pm
