GB
14
Activating the Alarm Function (AC Operation Only)
1. To activate the alarm function, repeatedly press the ALARM/SNOOZE button. The
alarm wake-up modes will be displayed and change in the below sequence on every
press:
Alarm Off
DAB Preset #
FM Preset #
Buzzer Tone #
2. When the display shows your desired alarm wake-up mode, stop pressing the ALARM/
SNOOZE button. The alarm function is now activated and an alarm icon will be
displayed.
3. When the alarm time arrives, the selected wake-up mode will be on and the alarm icon
in the display will flash to indicate that the alarm is triggered. To stop the alarm sooner,
press the button.
4. To check the alarm status, press the ALARM/SNOOZE button. The alarm status will
show on the display.
• If you have activated the alarm function and the wake-up mode is DAB or FM, make sure that the
volume is at a sufficient level for you to hear.
• If the wake-up mode is DAB and the DAB signal strength is low, the buzzer alarm will be triggered.
Automatic Alarm Repeat (AC Operation Only)
The alarm will automatically repeat each day at the selected time as long as the alarm icon
is displayed. To cancel this function, repeatedly press the ALARM/SNOOZE button until
“Alarm Off” shows on the display.
Snooze Function (AC Operation Only)
When the alarm has triggered, press the ALARM/SNOOZE button to temporarily switch
off the alarm for 5 minutes. The display will show “z” to indicate that snooze is on. Snooze
function will continue for 1 hour from the set alarm time.
To cancel snooze mode press standby to turn unit on then turn radio off. Alarm will be
ready for the following day.
Sleep Function (AC Operation Only)
This function allows you to program the unit to turn to standby mode by itself after a set
period of time.
1. To activate the sleep function, press the SLEEP button repeatedly and the “Sleep Timer”
shows on the display. The time will change in the below sequence on every press:
90
80
70
60
30
10
2. When your desired sleep time appears in the display, stop pressing the button and the
sleep function will be activated in two seconds. “s”will be displayed on the display.
3. When the sleep time counts to zero, the unit will turn to standby mode. To put the
sleep function off while the sleep timer is still counting down, press the SLEEP button
once, “s”will disappear from the display.
4. Press the INFO button repeatedly to show the sleep timer status on the display when
it is turned on.
SVDRB_W_WN12E IB_RC_130605_Michelle.indb 14
5/6/13 11:42 AM
