GB
11
Power Source
Mains Power
• This unit is designed to operate with an
DC 12V 1.5A power supply.
• Unwind the cable to its full length.
Connect the end of the cable to the DC
IN Socket at the rear of the unit then
connect the mains adapter to the mains
socket. Make sure the mains adapter is
firmly inserted into the mains socket.
The unit is now connected and ready to
use.
• To switch the unit off completely,
remove the mains Adapter from the
mains socket.
DC IN
Ensure all connections are connected before
connecting to the mains power socket.
Battery Power
1. Connect the mains adapter to the DC IN socket on the unit. Connect the other end to
the mains socket.
2. Battery will automatically start charging whilst in STANDBY mode, the BATTERY
CHARGE indicator will flash green. When the battery is charged to full capacity, the
BATTERY CHARGE indicator will illuminate green.
3. Remove the mains adapter. The battery is now ready for use.
• The battery is partially charged at shipment. Charge the battery to full for the first time use. It
takes about 12 hours at fully charged.
• When the radio is connected to the mains and in use, the battery will be recharged but at a much
slower rate.
• Do not disconnect the mains power adapter during charging.
• It is normal for the battery to become warm during charging.
• Do not use the battery under high temperature or near heat sources.
• During battery operation, if the battery becomes flat, the “Battery Charge” indicator will flash red,
you should change to AC operation and recharge the battery.
During battery operation, the button will work as a POWER ON/OFF button. The display will be
totally off when the radio is powered off. The display backlight will be dimmed in few seconds after
radio power on, and it will be turned to full brightness for 5 seconds on every button press.
SVDRB_W_WN12E IB_RC_130605_Michelle.indb 11
5/6/13 11:42 AM