10
-
.3. INSTALLATION SITE
-
.2. IDENTIFICATION
KD?JF7HJI
The main module may consist of three different sections: filter, coils and fans. However,
one of the first two sections may not be included. The following illustration identifies the
main components of the main module.
Electrical cabinet
Breaker
Heating battery
Cold battery
Drain
Fan section
Battery section
Filtration section
The unit must be installed so that the airfl ow is upright vertical position: Bottom air
intake and top discharge.
• Avoid installing the unit in areas near heat sources or in damp areas where the unit
might come in contact with water.
• It is recommended that the unit be installed in a place that is easily accessible for the
installation. Provide sufficient room for maintenance, connection and drainage of con-
densate.
-
.4. MAINTENANCE SPACE
• The installer should leave sufficient unobstructed space to allow free access to the unit
for maintenance. The amount of space needed will depend on which side of the unit is
performing the extraction. The unit is equipped with some side access doors for access
to the filters and fans. To remove the coils, the side panel must be removed. Both the
filters and the fans can be removed from either side of the unit.